It sounds like the contacts in the steering wheel itself are bad. Find the "hot" wire to the horn under the dash, use a jumper wire to bridge from it to a good ground. If the horn sounds it is bad contacts in the steering wheel. If it still does not sound check for a break in the hot wire between the fuse box and the steering wheel. If the horn relay were bad it would not work at all.
Inside the distriburator after you remove the rotor button.
It does not take fluid. There is no pump. Only an electric module.
Underneath the PCM on the passenger side front of engine compartment
where is the ignition module located on a 1988 Mazda b2200
You don't! While you can change the pump yourself, it will not work afterwards due to the fact that the module in the pump needs to have a pmi performed (programmable module installation) and this can only be done using the Mazda or Ford IDS ( factory scan tool). However, you can install it and then tow it to a dealership and ask to have the as built data entered for the module. You can expect to pay $100 to $200 for this procedure. Typical pump replacement would run between $200 and $300, and usually includes programming.
The airbag sensor module location on a 2000 Mazda B3000 truck is typically located in the center of the vehicle, under the dash, near the steering column. It is a small, box-shaped module that is connected to the vehicle's electrical system and is responsible for deploying the airbags in the event of a collision. The exact location may vary depending on the specific model and trim level of the vehicle. It is best to consult your vehicle owner's manual or a repair manual for the precise location of the airbag sensor module on your specific vehicle
The 1992 Mazda Miata is equipped with a non-adjustable steering wheel.
How do you replace power steering belt on 2003 Mazda protege ?1.6
body control module located
The Mazda Protege fuel reset button can be found on the firewall in the engine compartment. The reset button will be in the middle of the firewall.
you have to have your normal lights running first, then press the switch above the main cruse control button on the dash left of the steering wheel.
The daytime running light module is up under the dash just to the left of the steering column. It has one electrical plug going to it and one bolt attached to a plate holding the module in place. A bit of a tight spot to get to but easy to change. Had to do mine a while ago on my 2001 tribute.