my 1993 190E 2.3 is doing the same thing. just replace the switches...they tend to not last
you must combine two relais
5x112
The electric fan is operated by a switch on the aircond receiver drier. The engine fan on the water pump is operated by an electric switch on the front of the head
The 1985 Mercedes 190e could have a stuck choke. Check the choke mechanisms to start with, to see if that's the problem.
i hev spark electric problem an Mercedes 190 e 2.6 1989
how to repair a window motor on a 380sl mercedes
There is none, just relays! 2 relays and a relay with a 10amp fuse behind the battery.
The inertia switch on a 1985 Mercedes 500 SEL is located in the passengers side kick panel.
Its one of the two black knobs connected to the dashboard. i think its the one that resets the mileage. im pretty sure you have to push it in at twist to the right or left for on and off. hope that helps.
on my 1984 190e there is a nut that can be turned with the tools that came with the car.. the nut is located behind a plastic cover in side the trunk on the left side, near the left trunk hinge. but if the cable is broken, this may not work If roof opens then motor & cable are obviously functioning. Suggest checking switch. Also when switch is set to close can u hear sound coming from sunroof area: if yes then switch ok. My problem is opens fine but gets stuck when closing, and will only close by "pulsing " the switch, which would seem to suggest problem with the slide rail(s).
The 1985 Mercedes-Benz 190e has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
If Its Like the 1990 model, it doesn't have one. Simply open the car, and press the front end of the gas cover towards the front. That should do it.