answersLogoWhite

0

Mikuni idle adjust

Updated: 12/16/2022
User Avatar

Wiki User

14y ago

Best Answer

My 1340 evo with 42 HRS Mikuni idles fast after it gets hot no matter how i adjust the idle air screw. What am i doing wrong??

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Mikuni idle adjust
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you adjust the air and fuel mixture on Mitsubishi Galant 2000 mikuni carburetor?

Start at 1 1/2 turns from seat and adjust for best idle


New mikuni on your 99 evo has rattle at idle seller says its normal?

Yes, mikuni 42s commony rattle at idle on evos- not a deal-breaker- it's nothing.


How do you adjust the high idle speed on a 1987 Mazda B 2600?

There is a small screw adjustment on the drivers side, closer to the bottom back part of the mikuni carb. Remove the air filter and housing to get at it better


How do you adjust a mercury 150 outboard boat motor idle?

You adjust idle with idle timing


How do you adjust idle in the Mitsubishi diamante?

Adjust idle on Mitsubishi diamante


How do you adjust the idle speed on a 2001 Subaru Forester and what should the idle speed be?

how to adjust idle on 2001 legacy


How do you adjust idle speed for Toyota supra?

you can adjust it via the idle control valve.


How do you adjust idle on 2008 mitsubishi lancer es?

you cant adjust your idle, it is computer controlled


How do you adjust the idle control valve on a 1988 Caprice?

You do not adjust the Idle Air Control as it is controlled by the computor.


How do you adjust the idle on 1998 Toyota Avalon?

You dont adjust the Idle disconnect the battery for 10 mins and reconnect and the computer should relearn it idle .


How can you adjust the idle of your 96 sierra?

adjust the idle screw on the drivers side of the throttle body turn it to the right to lower you idle turn to the left to raise it


How do you lower toro lawnmower engine idle?

You adjust the run and idle speed with the governor wire...loosen the nut and adjust it.