My Van had a turn signal problem....I tested even the front lights....trun signal under the dash control....fuses.....rear break light switch.....and then while still under warranty took it to the dealer....only after sepnding 4 hours of self diagnosis 4 mechanics look the problem and finally replaced the whole wire harness at the rear tail light assembly. I suggest a junk yard visit...get the whole assembly and try it. good luck GTO JOE
It could be the rear window wiper fluid supply line broken. The wiper fluid supply line run directly over the back dome light. My 2002 Montana had the same problem.
Problem with plug shorting?
Good Chance this is caused by a faulty O2 Sensor. I had the engine light stuck on in my 2002 Montana and replaced rear O2 sensor and it turned it off.
Have the problem with the ABS repaired by a professional.
did you figure out how to? mine has the same problem
you need to clean the electric contacts on the rear lights, its just a earthing problem
How do you change the rear brakes on a 2008 Montana
means you have a problem in the rear brakes of your car. go to a mechanic before ya have a wreck
If you have a brake light at the top of your rear windshield, check those bulbs. Hard to determine if only one of them is out but that is probably your problem - worked for me. If you have a brake light at the top of your rear windshield, check those bulbs. Hard to determine if only one of them is out but that is probably your problem - worked for me.
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
Have the problem that is causing the light to go on repaired.
If the rear light of a Chrysler 300m does not turn on after replacing the bulb, a fuse may be blown. Replacing the fuse should fix it.