IF the sensor is part of a switch yes.
If you are replacing a 02 sensor with a new one I would cut off the wires at the sensor and slip a 7/8" box wrench over the sensor and remove it with a counterclockwise motion.
If you are replacing it with a new one I would unplug the sensor from the harness and then cut the wires off at the sensor. This will let you slip a 7/8" box wrench over the sensor and using a counterclockwise motion remove it.
bad o2 sensor Could also be a power brake booster going bad.
YA!
A motion moved by any member of National Assembly proposing a cut in the proposed budget for a particular Ministry/Division/ Department of the Federal Government is termed as Cut Motion.
No, it will not. Try replacing the belt.
air mass flow sensor
Not much info there but in most cases if you are going to replace it with a new one I would unplug the wire harness then cut off the wires at the sensor then you can slip a 7/8" box wrench onto the sensor and break it loose with a counterclockwise motion and remove it.
Yes it does cut your car off, The sensor is controlled by module that controls everything
Motion is not included with Final cut Express it is currently only available with the full Final Cut Studio suite.
If you are replacing it with a new one, unplug the sensor from the harness, cut the wires off at the sensor, slip a 7/8" box wrench over the sensor and with a counterclockwise motion remove the sensor from the exhaust pipe. Install the new one using a 7/8" open end wrench and tighten as you would a spark plug, reconnect the wires to the harness.