Drive your car off of a cliff
Turn the knob counter clockwise to remove it and clockwise to replace it. The "boot" is more then likely attached to the console that surrounds the shift lever.
There is a torx screw on the same side as the button, unscrew it half way and lift up the shift with the boot.
http://www.gmpartscheap.com/seccat/cavalier-697/2003/shift-boot-41002/124/
To change the shift knob on a Nissan 350Z, first, ensure the car is in gear and the parking brake is engaged. Gently pull the shift boot upwards to expose the base of the shift knob. Depending on the model, you may need to twist or unscrew the shift knob counterclockwise to remove it; some knobs may also have a retaining screw at the base. Once removed, install the new shift knob by reversing the process, ensuring it's securely tightened and the boot is properly positioned.
If it is a manual trans.take the screws out holding the shift lever boot on. Slide the boot up the gearshift. there will be a bolt holding the lever on, take that out and pull on the lever. you may have to get a little rough with the lever to get it to come off once the bolt is out.
To install a new shift knob and shift boot on a 2007 Honda Civic Si, first, remove the old shift knob by unscrewing it counterclockwise. Next, carefully pull off the old shift boot from the base, which may require removing the center console trim for easier access. Install the new shift boot by sliding it into place, then position the new shift knob and screw it on securely. Finally, reassemble any trim pieces you removed and ensure everything is snug and properly aligned.
To replace the shift boot on a Mini Cooper S, first, remove the gear shift knob by unscrewing it or pulling it off, depending on the model year. Next, carefully pry off the trim surrounding the shift boot, which may require a flathead screwdriver or trim removal tool. Once the trim is off, you can lift the old shift boot from its housing and replace it with the new one. Finally, reassemble the trim and secure the shift knob back in place.
lift the boot up and there is a set pin take that out and its off.... future references.... coloradofans.com has eveything you need to know
Pull down on the shifter boot. It should clip out. Then start twisting the knobe off... Left losy righty tighty
pull the shift boot down. loosen the jam nut under the shift knob then unscrew the shift knob.
gift sift soft soot boot boat beat beam team tram trap wrap
The snap rings that hold the shifter in place have popped out and you will need to remove the boot to put everything back where it belongs.