pull the shift boot down. loosen the jam nut under the shift knob then unscrew the shift knob.
To remove the standard transmission from a 1996 GMC Sonoma, start by disconnecting the battery and draining the transmission fluid. Then, support the vehicle securely on jack stands and remove the driveshaft, exhaust components, and any connected components such as the shift linkage and wiring. Next, unbolt the transmission from the engine, ensuring to remove the bellhousing bolts, and finally, use a transmission jack to carefully lower and remove the transmission from the vehicle. Always consult a repair manual for specific torque specs and detailed procedures.
Gear shift linkage?Remove gear shift from top and align
what makes a 1992 gmc sonoma 5 speed tramission quit when it gets hot
Haynes Repair Manual says: For manual tranny just twist the threaded knob off. For Automatic it says remove the 2 screws -- one on each side of the shaft -- on the lower part of the "shift lever grip", then lift off the grip. Good luck, YFC
The fluid capacity of a 1996 GMC Sonoma manual transmission is approximately 4 quarts (or about 3.8 liters) when filled with the appropriate transmission fluid. It's important to use the recommended fluid type, which is typically GM Synchromesh or an equivalent. Always check the owner's manual for specific recommendations and to ensure proper maintenance.
17mm (works for a 1998)
i have a 91 sonoma. For advice it was easiest to unbolt the the flywheel/flexplate cover. this allows you to wiggle the starter towards the front of the truck and then lower it down. ( you do not need to remove the cover; just move it out of the way.
fold seat down, then unbolt the frame of the seat, and remove them. it is a really simple process.
Remove the center console to get at the burned out bulb. Consult the vehicle manual to learn how to do this as different models may have slight differences.
the knob you can pry off
just turn it off
The shift interlock solenoid on a 1996 Toyota Avalon is typically located on or near the transmission assembly, specifically around the shifter mechanism. To access it, you may need to remove the center console or panels surrounding the gear shift. It's advisable to consult a repair manual for detailed diagrams and instructions specific to your vehicle model.