0
My son's 4-runner will not start and the battery checks out ok. When we turn the key we hear a click but does not turn over. I cleaned the batt cables but still the same. What can he look at?
Wiki User
∙ 15y ago
It may still be the battery. If you just hear a click, it may be the starter is out. Make sure the battery is charged to the fullest. Sometimes the battery will have power but not enough to work the starter.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Your E-350 van wont start there is a click sound when turning the key?
You should check your voltage on your battery first to make sure it is not dead. You should check your battery cables if your battery checks out to be fine
1995 corolla suddenly went dead won't start no instrument lights jumping didn't work Is it just a dead battery or something worse?
That's what I would check first. If the battery checks good, make sure battery cables are tight. Also check the fuse.
What is the name of the tool that checks remaining battery life of a battery?
Hydrometer.
95 Geo Tracker with a brand new battery is still is hard to start after sitting over night you were told by AutoZone that the Alternator was ok Could this be the starter?
Make certain the cables from the battery to the starter and the body are good...may be a starter check out your local library for a shop manual and the checks to make.. d
What is ISBMgr.exe?
ISBMgr.exe checks that you have Sony Battery, if you want to replace the battery with other brand you have to deactive this application.
How fix KIA Sophia after battery cables crossed now radio not working and idles poorly with backfire in air filter OK in reverse?
The first thing I would try is take the battery cables off for about 30 min. This should reset everything. Also check the fuse for the radio. You might want to go to your local part store and have them hook their computer up to see if it reads any fault codes... The mass air flow sensor could have stop working properly due to crossing of the battery cables... We have a Advance Auto parts that checks your car with their computer for free. Hope this helps and good luck A
What is the difference between an Insulation Resistance Test and a Continuity Test for Electric Cables?
A continuity test checks to ensure that there is no break in the conductors. An insulation test checks to ensure that the insulation is sound.
What does it mean when it says battery not charging?
because you have just plugged it in it checks if it is a charger
How can a person tell the different between problem with the battery and the alterator?
The quickest way to test the battery is to have it drop tested this involves using a tool to apply a load to the battery which checks it's ability to hold a charge. If the battery checks OK then the charging rate of the vehicle should be checked Both of these tests can be carried out by any good garage
Why your charge battery wont start car and also i hear clicking at fuse box?
Start with double checking both ends of both battery cables. Be sure the connections are clean and tight. Have the battery tested at your local auto parts store. You may think it is charged but it may be expired. If all that checks okay you may have a bad starter/solenoid assembly. The clicking you hear is normal, that would be relays doing their thing.
Egr problems on 94 olds ciera My mechanic has replaced the egr. Checked all connections except cleaning the plenum. After all these checks the light still comes on. Any suggestions?
disconnect battery cables for minutes then reconnect them, this should reset signal in computer if problem has been fixed
Why Engine cranks slowly?
If an engine is cranking slowly the first thing I would suspect is a weak battery. Remove both battery cables and clean both the cable connectors and the battery posts. Put a battery charger on the battery and charge it until if is fully charged. If the problem still persists, then suspect a starter going bad or the engine is slow in time. Remove the starter and have it tested at an auto parts store. If the starter checks OK, then you need to have the engine timing checked. If your Check Engine light is on, have the ECU scanned for a trouble code and go from there.
