Want this question answered?
no
According to the instructions.
Just plug in all of the light sets in to the outlets on the provided extension cord.
The turn signal flasher is located in the same assembly as the hazard button the dashboard just above the stereo. You need to remove the trim pieces from the dashboard in order to access the flasher assembly.
you must remove the inside trim panel and unbolt the assembly from the inside
Access the fog light by removing the headlamp assembly. You will need to remove some of the screw clips on the plastic trim panel at the front of the engine bay to reveal the retaining bolts for the headlamp assembly. After removing the assembly, the fog light can be easily accessed.
you have to remove to entire headlight assembly 2 screws on top and 2 nuts on the backside of assembly that go through metal panel
Consult the aircraft's instructions for the launch configuration for the best glide speed. To launch at and maintain this speed, you may need to specifically trim the aircraft's surfaces.
If it is a diesel, remove the battery on the side you need to get to. Then unscrew the 2 Phillips head screws on the top on that side, and then below the battery mount there will be 2 7/16" bolts below the headlight assembly, remove those and the assembly should come out.
If you have already ordered a new top there may be instructions in the box, but beware, it is not as easy as it looks, we own a trim shop and people think there is nothing to replacing conv tops, wrong, it takes a ton of patience and some basic know how, if your a handy person, may be able to do this, if not, call a trim shop in your area. Too much information to post here. Good luck, you will need it.mxqng
Remove the two bolts that hold the whole trim assembly together. Remove the outer trim and turn signal and then the marker lights to change them.
Don't, there is no need to trim a cats claws.