Go to Motorcraft service.com.
Click on Owner Guides
You can view the 2000 Ford Windstar owners manual online ( it includes
the fuse diagrams )
According to the 2000 Ford Windstar Owner Guide ( 5W-30 )
the transmissions are different 2000 takes ax4s 2001 take ax4n motors would fit some sensors make need to be transfered
The blower on the back heater may need to be replaced on the 2000 Ford Winstar.
You don't need to turn back the speedo you cheating, lying, scumbag!
According to the owners manual, the Windstar is happy with plain 87 octane. Anything higher is not necessary, and doesn't improve performance or mileage.
EBAY IS THE BEST PLACE TO BUY JUST ABOUT ANYTHING YOU NEED
You can find a transmission cooler for a 2000 Ford Windstar at most auto parts stores although they generally will need to order the part and have it shipped to your local store. In general, these coolers cost around 50 to 100 dollars.
The bulbs can be replaced for the radio and heater controls on a 2000 Windstar SE by removing the plate over the heater controls. Some models need an Allen wrench for this and some models will need a Star wrench to remove the screws holding this plate on.
To access the speakers on a 2000 Malibu, you will need to remove the door panel. You also may need tools like screwdrivers and a wire cutter to take the door panel off. Before starting any removal of the panel, you should disconnect the negative battery cable.
check the striker plate may need to be replaced or tightened
According to the 2000 Ford Windstar Owner Guide : -------------------------------------------------------------------------- If you have the 3.0 liter " Vulcan " V6 engine it either came from the factory with the Motorcraft BXT - 59 battery or the optional BXT-65-750 -------------------------------------------------------------------------- The 3.8 , V6 had either the BXT-65-650 or the optional BXT-65-750
Which panel are you in reference to? The kick panel or the door panel? If it's the kick panel there is a plastic rivot you need to pull out loctated on the forward portion, then you will need to remove the lower plastic from the floorboard that lines the door opening, then you will be able to pull the panel towards the door opening and it will pop right out.