61 - 69 ft-lb
The B2600i does not have an EGR valve, because the truck is fuel injected the ECU monitors driving conditions and retards ignition timing to lower NOx emissions. Kyrasis6 Mazdatruckin.com
A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.
The 1993 Mazda. reverse light switch is located below the shifter column. The relay switch can be seen by removing the center console.
The 1993 Mazda the inertia?æswitch can be found on the firewall in the engine compartment. The inertia switch will be on the passenger side of the firewall.
The neutral safety switch, release switch, or brake switch is bad.
I've attached a link to a B2600i vacuum diagram that has been color coded as well as some additional materials for your reference in the future.
I found a listing for a 1988 Mazda B2600 ( 2.6 L 4 cylinder engine / 3 speed automatic transmission / 4X4 ) and listings for 1990 through 1993 Mazda B2600I ( 2.6 L 4 cylinder engine / 4 speed automatic transmission / 4X4 )
Any Mazda pickup produced AFTER 1993 is a FORD RANGER. If you can find diagrams or instructions for a 1994 Ford Ranger it will be the same as your Mazda. Ford at one time owned a 50% stake in Mazda, and didn't like the competition from Mazda's pickups (much more reliable) so they halted the sale of Mazda's in the U.S. and branded their Ranger pickups with the Mazda name and number designations (B-3000, etc.).
I have a 1993 Mazda Protege LX and I was told that there is no relay for the horn, there is a horn switch inside your steering wheel. that might help
Either your handbrake switch is broken and will not turn off or you have low brake fluid.
Would not have a neutral safety switch - may have have a clutch safety switch usually located at the upper end of the clutch pedal under the dash area