Firstly, remove the kit of the car, other words lift the entire body off the car. then go to panel beater and get lights, then with very good presicon get a hammer and remove the old light, then replace, by body back on and presto or bob's is actually your uncle.
you have to remove the bumper in order to remove the lights :)
In order to replace your tail lights you need to first remove your rear bumper, there is a screw on both sides, and a 1/4 in bolt on both sides, you then need to open the trunk and remove the bolts on the inner left and right side ( you may have to remove the plastic black oval covers), remove the two clips on the bottom of the bumper pull the bumper out and away from the vehicle. at this point you need to remove the snap bolts holding the trunk liner. you then unloosen the three nuts on each tail light and the screw on the bottom of each tail light, under each tail light there is a black bracket which will need to be loosened also, you then disconnect your lights and slowly remove the tail lights out. installation is the reverse, be sure to tighten the black bracket in place, good luck.
with a hammer
Get a rock
You can access the Nissan taillights from the cargo compartment. Remove the tail light assembly cover. Remove the tail light wiring harness. Remove the tail light assembly retaining bolts.
You dont actually remove any panal. In your trunk should be some bolts, either plastic type, or metal, right behind the tail lights. These need to be removed. Once removed, you can wiggle the tail light off the car, and replaced the affected tail light bulb.
Open rear door hatch. There on top of the rear tail lights you will see two or three screws. Remove those screws and gently remove the tail lights. When your done with the tails lights reinstall.
Remove tire and inner fender well and change it from there. Other option is to remove the licence plate and reverse lights,reach through to the tail lights.
The tail lights on a 2006 Honda Civic are mounted to the brackets in the trunk of the car. Open the trunk and remove the mounting bolts. Unplug the bulbs and the housings will then be able to be removed.
drop the tailgatethen remove screw holding lights in bed
4 screaws remove lences
Remove the carpet behind the tail lights and you will see the mounting sockets for the bulbs. I agree, it's a dumb arrangement.