There is a styro-foam sound deadening piece in the door It measures about 6in tall and 24 in long . the one on my driverside door came loose inside and would stop the window 1/2 down.
STEP 1) 3 screws in bottom of door, 2 more in the handle. to remove the inner door skin.
STEP 2) Unbolt inner door skin from door.
STEP 3) Either RE GLUE the styro to the door or remove it completely ( Recommend that you reglue it.
reverse the process and DONE .
you prolly need a new window motor... check a local junkyard.
Take off door panel and grease window track. Regulator motor may also be worn which would cause slow close condition.
what it is called a part of the window that makes window glass of Volkswagen new beetle goes up and down?
window regulator
If by " rolls down all by itself" you mean that it slowly slides down while traveling in the car, then my advice would be to take the door panel off and check to see if the window came off the the lower clips. If every thing looks sound and or the window is electronicly rolling itself down I don't know what to tell you.
73 nova is the only nova were the back window rolls down
You can tell if your window regulator is broken on a Volkswagen Beetle when you hear a big clunk as it goes down.
Take ArmorAll that has the straw with it and roll the window all the way down or as far as it will go and spray it down on the inside of the door which is the inside of the door and that should help loosen the hinges making it easier to go up and down try this and see if it works ok.
If the 2002 Beetle window is crooked, then the problem could be that the window track is loose or damaged. If the electric system wont move the window up or down, check the fuse and window relay for a problem.
im assuming this is power windows. your motor could be shot, yes even if it goes down the motor can be bad. or your regulator is screwd up, but it sounds more like a motor problem to me. I have the same problem in a 2000 Corolla, and it is a bad motor. Mine is the rear window on the driver's side.
From my 07 manual:Start the engine. Push down and hold the driver's window switch until the window is fully open.Pull and hold the driver's window switch to close the window completely, then hold the switch for about 2 seconds.
it rolls the window up and down, but that's not the problem. it's your window switch, very easy to replace and not exspensive at all, it's a plug in part