0
What else can I help you with?
Can you solder a brass fitting to copper?
Certainly look up Flagg Flow T.P Fittings T.P thread-less copper fittings will FIT on schedule 40/80 /120 Brass pipe Ideally it should be brazed but soldering will hold domestic water pressures Also many solder fittings ARE CAST BRASS rather then wrought copper
How long can you weld underwater?
How long can you hold your breath?
What is the process for joining ABS pipes using solvent weld?
To join ABS pipes using solvent weld, you need to first clean and dry the pipe ends. Then, apply ABS cement to both the pipe ends and the fitting, and quickly push them together. Hold the joint in place for a few seconds to allow the cement to set. This creates a strong, permanent bond between the pipes.
How much pressure can JB Weld hold before it fails?
JB Weld can typically withstand pressures up to 3,960 psi before it fails.
How tin used for in a mobile phone?
Tin could be in a mixture with lead to form the solder. Solder is used to hold the components to the printed circuit board.
What will you do you feel vomit when fitting dentures?
pray to god you can hold it in.
Explain how to apply tinning technique in soldering?
Strip the wire to desired length. Then hold the wire horizontally and hold the soldering iron underneath the stripped part while holding the solder on the top of the wire. When the wire gets hot enough it will suck the solder into the wire
Is it safe to use permatex plastic weld on a car radiator?
I doubt very much it will hold.
What are fifty year old rugby jerseys made out of?
There were made of thick cotton. Very hard wearing and very loose fitting. Since the union code went professional more time and development was put in to the jersey of today which are very tight fitting and stop opponents getting a positive grasp to hold the player
How do you remove a brass fitting from a galvanized fitting?
Two pipe wrenches. One to hold the galvanized from turning and one to turn the brass fitting. Pull on one and push on the other and it should come out.
How do you replace the battery terminals for 97 Buick LaSabre?
Remove the old terminals, a large pair of bolt cutters or a hacksaw should get the job done.Strip the ends of the wires with a knife and check for corrosion which will be black or green.If there is corrosion you need to replace the cables.If there is no corrosion replace terminals with screw on type for convenience or use solder on type if you prefer.For screw on just put the cable in the terminal and tighten the screws.For solder on you will need to to hold the terminal in vice grips and heat it with a torch and feed solder into the terminal while the terminal is hot. When the terminal is mostly full slowly dip the cable into the solder and hold there while you remove the heat. You now need to hold the cable perfectly still in the solder for about a minute or the solder will crack while drying and you will have a poor connection.Reconnect terminals.
Why lead is used for soldering purpose?
Because it melts easily and is good in a solder mixture to hold wires together.
