answersLogoWhite

0

Noise around the belt on 1989 Celebrity?

Updated: 8/17/2019
User Avatar

Wiki User

14y ago

Best Answer

You need to be a little more specific about the noise around the belt. I would suggest you check out the serpentine belt as it could be failing. If it is a grinding or squealing noise it could be a failing bearing in one of the units the belt powers.

I hope this is of some help, if not ask again with more information.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Noise around the belt on 1989 Celebrity?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you find a belt diagram for a 1989 Chevy Celebrity?

On some cars there is a sticker in the engine compartment with a belt diagram.


How do you fix a squealing noise around the Pulley the serpentine belt area?

Spray hairspray on the belt if it is making the noise or replace the belt or the pulley if its making the noise.


How do you replace a serpentine belton a 1989 Chevrolet Celebrity?

To change the serpentine belt on a Chevy Celebrity: 1. Make note of the routing so you can get the belt back correctly. 2. Use appropriate breaker bar or ratchet to release the tensioner then take the old belt off. 3. Put the new belt in place, releasing the tensioner to get the belt over it.


Your Nissan pickup has a clicking noise around the belt?

is your belt tight enough,does it need replacing,check your belt tensioner to see if the bearings are bad.


Could a faulty alternator make a noise that sounds similar to a belt going around and around in a 2001 Mercedes C240?

It is possible but to correctly diagnoise a noise you have to hear it.


How do you replace the belt tension er on a 1989 Chevrolet celebrity?

To replace the timing belt tensioner on a 1987 to 1990 Chevrolet Celebrity V6: 1. Use a 3/8" breaker bar to release the belt tension, move the belt out of the way. 2. Remove the single bolt out of the center of the fixed end of the tensioner. The belt tensioner will now come off. 3. Install the replacement tensioner and put the belt back on.


Squealing noise around belt on 1993 Chevy silverado?

check for bad bearings in alternator OR TALK BELT OFF THEN RECRANK. IF STILL MAKING NOISE SPRAY WD 40 ROUND YOUR THROTLEBODY. CAREFUL IT IS FLAMEBLE. SEE IF NOISE STOPS OR QUITENS. I RE-BUILT MY ALTERNATOR YESTERDAY SILL MADE NOISE, CHANGED BELT AND BELT TENSONER LAST NIGHT THEN IT MADE NOISE AGIAN. WHILE IT WAS MAKING NOISE TODAY ME AND MY SON TOOK BELT OFF STLL MAKING NOISE "NOT BELT OR ANY PULLIES" SPRAYED THROLTE BODY WD 4O FOUND IT IS SUCKING AIR WHERE CABLE WORKS THROTLE MAKING THE HIGH PITCH LOAD NOISE. THE NOISE GOES AWAY WHEN SPRAY. WASTED 135 YESTERDAY ON PARTS


How can you make the belt on a 1994 gmc van quit making noise?

It depends on the noise. If it is a squealing noise it is probably a loose belt and needs to be replaced. Check the back of the belt if it is "glazed" meaning slippery and shiny then replace the belt.


A squealing belt on a 2001 GMC sonoma?

A worn belt will cause a squealing noise. The squealing noise is caused when the belt slips. Tightening the belt will temporarily fix the problem.


Is there a timing belt on the Chevy celebrity 1987?

no


Must you remove the camshaft to replace the timing belt of a 1989 Chevy Celebrity 4-cylinder?

no The Chevy Celebrity 4 cylinder engine doesn't use a timing belt, it uses a timing gear. To replace the gear it is necessary to remove the camshaft from the engine as it is a press job. To remove the camshaft it is necessary to remove the engine from the car.


2000 Chrysler Concord has noise had ac belt off no noise back on yes replaced ac compressor still noise Could it be the belt tensioner?

Yes