Yes
Oils and water are not miscibles.
Yes
No, it is a physical process.
very bad! change the oil
The primary emulsion is formed by mixing the entire amount of oil with the gum, adding the water required for the primary emulsion all at once and mixing vigorously until a thick and sticky emulsion results.
The primary emulsion is formed by mixing the entire amount of oil with the gum, adding the water required for the primary emulsion all at once and mixing vigorously until a thick and sticky emulsion results.
The primary emulsion is formed by mixing the entire amount of oil with the gum, adding the water required for the primary emulsion all at once and mixing vigorously until a thick and sticky emulsion results.
if you have have water mixing with the oil then your cylinder head gasket might need replaced if it is not overheating just give a good run, when the oil heats the water will evaperate
It is a physical change because the oil and the water do not change in chemical composition.
Change your oil cooler.
No. After mixing them, they settle into two separate layers (oil above the water) without any new substance formed.