Oil Pump Removal & Installation4.6L and 5.4L Engines1. Remove the timing chain. 2. Remove the oil pan. 3. Remove the three oil pump screen and cover bolts, then remove the screen and cover. 4. Remove the oil pump screen and cover spacer. 5. Remove the four oil pump mounting bolts, then remove the oil pump from the engine. To install: 6. Clean and inspect the mating surfaces. 7. Install the oil pump and loosely install the four oil pump mounting bolts. Tighten the four oil pump bolts in sequence to 71-106 inch lbs. (8-12 Nm). 8. Install the oil screen and cover spacer to 15-22 ft. lbs. (20-30 Nm). 9. Install the oil screen and cover, then install the three oil pump screen and cover bolts. Tighten the bolts near the oil pick up screen to 15-22 ft. lbs. (20-30 Nm) and the bolts at the opposite end of the pick-up to 70-106 inch lbs. (8-12 Nm). Install the timing chains, then install the oil pan.
half inch..
I am looking for the location of the oil sending switch on a 2000 F150, or where I can see a diagram or picture of it. Thank You
Repair or replace the oil pump, or replace the valves, if the oil pump is working properly.
The 1998 F150 could have low oil pressure due to a stopped up filter, clogged screen, or bad oil pump. The pump and screen are inside of the oil pan.
In the oil pan
Remove oil pan
Imagine a straight line directly down from the center of the distributor. The oil pump is in the bottom of the engine and straight down from the distributor.
The oil pump is bolted to the bottom of the engine , inside the oil pan
The oil pump is bolted to the bottom of the engine INSIDE the oil pan
front of the vehicle drivers side above the front axle
In the oil pan under the oil filter the filter screws onto it
need instrution for removing the oil pump from f150 v8 1997 4.6 truck