It's possible. Disconnect the negative terminal on the battery, then disconnect the ECU.
The computer on a 1999 Aurora can be replaced by first disconnecting the battery and removing the wiring harness to the computer. It can then be unbolted from its housing and a new one put in place.
The computer may not be enabling the fuel pump. If the fuel pump works when connected directly to the battery, it is good. If it won't work when connected to the wiring harness, then the computer might need to be reset. This involves disconnecting the battery for a little while, say, half an hour.
COmputer, loose battery, defective battery/volt amps or loose wiring harness/ wires grounding out somewhere
The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.
The alternator on a Chrysler 300m can be replaced by disconnecting the battery, removing the wiring harness from the alternator, and then unbolting it from the mounts. The drive belt can then be slipped off and a new alternator put into place.
The starter on a 2005 Honda Accord is replaced by disconnecting the negative battery terminal, removing the starter shroud, and unbolting it from the block. The wiring harness is then disconnected and the replacement starter mounted.
can you used a 2.0 liter complete witing harness for a 2.4 mitsubishi eclipse spyder engine
It is located in the engine compartment usaually behind the battery on the fender well. Your main wiring harness goes to the computer and the plud is secured by 1 single screw in the center of the harness connecter. Good luck
The starter on a 1995 Cadillac DeVille is removed by disconnecting the battery, unbolting the starter, and lowering it slightly. The wiring harness can then be disconnected, the starter removed, and a new unit put in place.
All connectors relating to airbags will be yellow. Be advised airbags are dangerous, if you intend on disconnecting anything airbag related be sure to disconnect the battery to avoid any injury.
The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.
It is not possible to Jump Start your Harley using the battery tender wiring harness. The battery tender wiring harness has a 3amp inline fuse that will blow if you attempt to do this.