You can either replace the switch or temporarily, jump across the connections. This will move the window to the up position. Better answer.... The switch needs to be plugged in, in order to jump the connections. Remove the plate that cover the inside handle, unplug the power door lock. Now you have access to the underside of the window switch. Unplug the switch and pop it out (pry the lock tabs in). Remove the bottom white plate off the switch. This gives you access to the conncetions. Look at the wire harness plug, it has letters on it, A, B C D on one side, E - H on the other. With the white plate off, plug the switch back into the wire harness. Jump E - H (blue to light tan wires) with the ignition on). Be carefull not to hit anything else. I used electrical tape to protect the inside of the switch. The window will rise. And then onto E-Bay to buy a used switch.
no monte carlos r2door i have never seen a 2 door impala so no
A blown fuse could be the reason the window will not go down on your 1988 Chevy Blazer. Another possibility is that the switch is worn out or has a loose, broken, or corroded wire.
The 1999 Chevy Monte Carlo does have an emergency fuel cutoff switch. The emergency fuel cutoff switch can be found in the fuse box.
yes
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
check for broken wires in the door and check for pawer across the switch drive safe
If there is any of the window up and you can grab it you can pull it up and then with both hands, one on each side, push the window up. If it is completely down you can't do it. How about removing the power window switch and either replacing it or wire around it long enough to get the window up.
Do you mean how to tell if it is broken?
Its pretty easy, as long as you have or have found a new switch. You just have to go to your local Chevy Dealer
How to repair electric windows depends on what is wrong with them. If the motor that runs the window has burned out then replace the motor. If the switch is faulty then replace the switch. Check for broken wires, repair them if found.
autozone had one for me
take the door panel off and disconect the wire assembly or window regulator that goes to the power window moter and manually pull the window up.