the head has to be removed in order to get the drive out all of the way, but the easy way is to cut a notch at the top of the drive where it hits the head to get to the oring while it is still in the block then slide the oring over the top (after soaking in hot water is easier) once you get the new oring on get a SBC dist. gasket, splice it and put it around the top of the drive, the get some RTV silicone and goop it up to seal the gasket back together, this way takes about 2-3 hours and is WAY easier than removing the head,
no it is not possible
No, you can replace the grill without removing the radiator.
Remove fuel tank Remove fuel tank sender and fuel pump assembly usually by removing a locking ring, replace pump using supplied hardware and replacement line. Reverse to install
remove bolts and replace it how do u think
Begin by removing the tire and wheel from your 2000 Chevy Lumina. Remove the brake spring and the break caliper. The rear brakes will come off.
Just remove pan and change bearings.
no have 2 remove tank
I recently replaced the alternator on my 96' Lumina. 1. Remove the serpentine belt off the engine by locating the belt tensioner and removing the tension req'd to remove the belt. (there is usually a diagram in the engine compt. showing the tensioner location and belt path) 2. Remove required bolts (2) I believe... & elec. harness plug from alternator. 3. Replace alternator & reverse process.
remove the 2 bolts andharness
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
You must remove the fuel tank, unless you can access the pump without removing it. I have seen some people remove the bed instead of removing the fuel tank. Your choice.
To replace timing chain on a 3.1 Chevy Lumina engine, you need to first make sure that your motor or engine is turned off. Then you need to remove the chain and replace it.