front brakes
Housing uses steel wire
the supply of housing is inelastic -Apex-
The housing used for a detection antenna is called a radome. This type of housing is made from transparent material, which is often found on the outer surface of an aircraft.
Generally in old houses an buildings.
Abraham Levitt built several Levittowns in the post-World War II era and may be considered the inventor of track housing.
Hydraulic and the slave cylinder is in the bell housing.
the differential is the large ball looking thing in the middle of the rear axle housing
In an automobile, the differential allows each of the driving wheels to rotate at different speeds, while supplying equal torque to each of them. In automotive applications, the differential and its housing are sometimes collectively called a "pumpkin" (because the housing resembles a pumpkin).
It is a hydraulic motor housing containing a vane that turns the shaft when hydraulic fluid is pump through the motor.
the recommendation for the differential housing cover bolts is 16 ft. lbs.
Between the 2 back wheels , in the center (differential housing) where the drive gears are
The differential, often referred to as the "rear", is the gear housing which transmits the rotation of the driveshaft to the rear wheels. A four-wheel drive truck also has a differential for the front wheels.
The hole in the bell housing, on a C12 Caterpillar diesel engine, can be found on the bottom of the bell housing. The hole faces straight down.
Inside the rear axle center housing.
In the tail shaft housing. you have to remove the drive shaft and the tail shaft housing to get to it.
That will depend on which differential you have. There is more than one. Find the metal tag located under one of the differential cover bolts on the rear end housing.
it's on top of the differential, which is on the driver's (U.S.) side just behind the transmission (the axle goes directly from the wheel into the differential and the speed sensor is on top of the differential housing).