Headlights Tail and Brake Lights
Geo Prizm
Mazda Protege

On a Mazda Protege why is the AC not cooling the indicator light goes off and on?

323334

Top Answer
User Avatar
Wiki User
2005-09-05 01:52:16
2005-09-05 01:52:16

The system is probably low on refrigerant so it is short cycling. A basic recharge should cure it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Typically the light will remain on if the fluid is low, or maybe the ebrake just pulled just enough that it is on..... or the switch that is triggered by the handle is faulty

User Avatar

On a Mazda tribute, the car with a key light indicator means that the engine is started.

User Avatar

Above the brake pedal,its black plastic.

User Avatar

probably the parking brake indicator

User Avatar

The HOLD light means you have an electrical problem with your transmission. See your mechanic ASAP.

User Avatar

It is run off of the same fuse as the engine computer.

User Avatar

Have vehicle scanned at auto parts store--most will do this free

User Avatar

Short in dash cluster is common on mazda tribute

User Avatar

You have a problem with the charging system. More than likely the alternator has failed.

User Avatar

To check the hold light blinking of a Mazda Protege, take off the plastic over the shifter tube or bar. Then take off the console below it and look at the wires that come up from the hollow center of the tube. The edge of the shifter tube may have cut through the wire insulation.

User Avatar

ABS equipped vehicles have an indicator light to warn of trouble. The light should come on for a couple of seconds when you turn on the key. If the light were burnt out, you could look under the hood for an abs controller near the master cylinder, or wiring to the brakes for a speed sensor at each wheel.

User Avatar

Remove the high mount brake light retaining screws from your Mazda Protg. Remove the high mount brake light wiring harness. Reverse the process to install your new high-mount brake light.

User Avatar

I suspect your hold switch on the shift lever might be bad..or ahs a broken wire.

User Avatar

you dont have strap on light cars just on pick-up's and big trucks

User Avatar

car stalled at red light and will not start. there is no spark from spark plug, help!

User Avatar

The alarm warning light in your 2002 Mazda Protg is an indication that the alarm system is deactivated. Remove the alarm fuse, for 10 seconds. Put the fuse back into its original slot.

User Avatar

There is none, except for Japanese versions if I recall.

User Avatar

The hold light is a warning indicator. Essentially, the flashing indicates that there is an electrical problem with the transmission.

User Avatar

I think its on the driver side there should be a panel on the right hand side near the excellerator


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.