take the light fitting back to supplier and make them get you the right one
All depends on the vehicle application. Usually you can disconnect the harness connector and remove from hose attachments or pushed into the charcoal canister assy.
Sometimes you do. If the new fuel pump came with a substitute harness you will need to. The reason is that a change has occurred possibly due to a recall and the old harness won't fit the replacement pump.
Step one is to get the correct fitting wiper blades. Once you do, the replacements should have step-by-step instructions. See related link below. Lookup the correct part numbers for your replacement wipers by make, model and year of vehicle which ensures correct lengths and attachments.
open rear trunck lid. you will see fittings for the lights in rear light assembly. locate the fitting for the light that requires replacement. turn fitting counterclockwise and pull out. pull light bulb out of electrical socket.
Quick disconnect. You can get the replacement part that is in the intake at Autozone. If you dont want to do that you cat replace the fitting with a old style one and cut the end of the hose of and slide it on.
Follow the wiring harness from your blinker. Disconnect the factory harness from the relay. Replace with the new relay.
you have to take the entire assembly out the bottom of the car. Be careful when getting replacement parts as there are a number of part numbers available with deifferent harness connections
Assuming you are asking about a 4.0L engine... Remove the distributor cap. Remove the rotor. Unplug the camshaft positioning sensor from the harness. Lift carefully where the cable feeds through the distributor to the CMP and remove. Put replacement CMP in the same place and connect it to the harness. Replace the rotor and distributor cap. Courtesy of xjtalk.com
The starter on a 2005 Honda Accord is replaced by disconnecting the negative battery terminal, removing the starter shroud, and unbolting it from the block. The wiring harness is then disconnected and the replacement starter mounted.
replace the harness
replace the harness
replace the harness