Need to check the ground and the connection were the bulb goes into the socket.
Around 5800-6000 lbs
if you read the owners manual there is a code you can put in yourself. It will tell you how to do it.
changed battery engine light stays on
Make sure it's getting a good ground. If you are sure that it is, you're going to have to use a test light to follow the circuit out.
11 mile per gal around town - 15 on the highway :(
no you wait till you it changed
The perform service light is to let you know when your oil needs to be changed and other fluid levels checked. The milage intervals can be changed in your display.
i dont have a manuel so i dont know what fuse to be changed,tried the one for radio-int light but that wasnt it. i dont have a manuel so i dont know what fuse to be changed,tried the one for radio-int light but that wasnt it.
no a 2003 suburban is not one wheeled drive, if it was you would drive in circles all day. so if someone told you that it was... tell them to go check their blinker fluid.
The dome light fuse on a 2003 Jeep Liberty can be changed by first locating the fuse panel near the hood release. The dome light fuse can then be pulled from its socket and a new fuse put in place.
Do not go changing parts as that can be very expensive and still not solve the problem. If the check engine light is "on" then have a shop diagnosis it for you. If it is not "on" then the most probable cause is the air intake and or the throttle plate are dirty.
need at least 5 gallons of gas in the tank. fuel injection requires that much to be effective.