0
Once you started the car the first time you brake you would have to rarely touch the brake to stop then the second time you brake you would have to press really hard what's wrong?
Wiki User
∙ 14y ago
When you hit the brake hard 2 times in less than 3-4 seconds it is normal, because the pump doesn't have enough time to build up pressure.
If there are at least 3-4 seconds between the first and the second pressing of the pedal and you still have this problem, may be the pump isn't working well.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does my brake peddle on a 1992 jeep wrangler go to the floor when started up?
Very common, as long as the brake pedal comes back up after the engine is started its good. It takes a second for the brake booster to build up pressure.
What are the two fluid lines that run to the front brake assembly on my Kia sportage?
brake fluid line and antilock senor cable( the second one is really a cable that looks like a line).
Brake rotor runout?
Brake rotors are rarely perfectly flat or centered. "runout" is the Word used to describe how far from perfect a rotor is.
Is a back up light bulb the same as a brake light bulb?
Rarely, Brake liight bulbs generally have two filaments. Backups generally have one.
Why is my gear shifter locked .my car is started but will not shift into gear?
the brake interlock press on the brake to release it
What is wrong when 2003 Pontiac sunfire started stalled started brake pedal was hard to push when trying to back up and stalled?
why is my brake pedal hard on 2003 sunfirer
Where is the brake shift interlock solenoid located on a 1999 Ford Windstar?
It is on the steering column, but those rarely go bad. In fact, I have never had to replace one. Almost always it is because you have no brake lights. Possibly a bad brake light switch.
Why do my brake brake lights only work when i press the wires on turn signal arm 1998 lumina?
the blinker switch shorted out the brake lights... really really common problem, need to replace the switch
What is replaced with brake repair?
Most often a brake repair simply involves replacing the brake pads. If the pads have worn too much though the rotors or drums will also need to be resurfaced or replaced. In more serious cases the master cylinder that controls the brake pressure will be replaced. Brake lines rarely if ever need to be replaced.
Where are the brake light fuses Pontiac Montana?
The brake light fuses can be found in the fuse box. The brake light fuse will be in the second column, fourth from the top.
What tool do you need to remove a 2001 dodge Dakota brake caliper?
a brake caliper tool (really)
Which is the anti breaking technology in car?
It a brake system rarely seen in new models.when a fast going car suddenly press the brake the brake system will not work and wheels stuck it led to out of controll. when the anti brake system installed in car the car will suddenly stop,the wheels work fast and not roll....
