My understanding is that this indicates the BCM has detected an incorrect voltage signal from the Passlock sensor (part of the ignition lock cylinder) at some time after you started the engine. This is a situation that must be corrected to prevent a similar incorrect voltage being read during starting, which would cause the car to non start.
It is very common for this to happen on these cars. To fix the problem, you will need to replace the lock cylinder. Your GM dealer parts department and many mechanics and locksmiths can set up (code) the new lock cylinder to your existing key so that you do not need a new key.
I strongly recommend replacing the ignition switch whenever it is necessary to replace the lock cylinder.
It is possible, but very rare, for corrosion at the BCM wiring connector to cause the same symptom, as can a fault inside the instrument panel cluster itself.
Instruction for replacing the lock cylinder and ignition switch are available on this web site as part of answers to previously asked questions.
A gearbox warning light that stays on even when the fluid light stays on may mean that there is something more serious going on with your car. Your Fiat should be taken to a mechanic to get checked.
I noticed while driving my Impala the temps stays at the normal operating temp but while sitting still the car runs near hot. I don't believe my fans are turning on when they should and if this is the case how do I address it?
Why does all the gauge lights come on while driving a 1998 S-10 pick-up.Seems to lose power. Go out and security light stays on.
More than likely the alternator is defective or the belt is loose.
There is a fault in the engine electrics. The light means "Fix Me".
I thought with the s-light on you put the car in sports mode from the button on the side of the gear shifter. I had this happen and actually had fun driving the car a bit faster than usual. just click on the button again to make the s-light come off. Computer has placed the transmission in limp mode. Take it to a transmission professional as you have a serious problem.
There are different types of light. Some you have to turn on, some they are automatic light (they turn on right when you start the car)
Each state has there own laws on how long driving after suspension stays on your driving record. For example, a suspension stays on record for three years in California, but in Michigan it stays for seven years.
The abs light comes on at start up for a few seconds to do a bulb check. If it stays on or comes on while driving and stays on the computer has detected a malfunction and set a code.
check your brake fluid level and fill with brake fluid to the top of the master cylinder reservoir.
dome light stays on ford taurus
It tells you the ABS system should be checked if the light stays on while driving. It could also be an electrical problem like the ignition switch.