Its 0.7 times peak-0 voltage, 106 mv RMS.
When you say holdhold supply of 230volts, you are referring to the RMS value, not the peak value.
It is the highest value of the amplitude, called the peak value. Scroll down to related links and look at "RMS voltage, peak voltage and peak-to-peak voltage". Look at the figure in the middle below the headline "RMS voltage, peak voltage and peak-to-peak voltage".
The average voltage is the rms voltage.Volts peak = volts RMS times 1.414Volts RMS = volts peak times 0.7071Use the link below to an RMS voltage, peak voltage and peak-to-peak voltage calculator.********************************The average voltage is not the r.m.s. voltage.The average voltage of a sine wave is 0.636 x the peak value. Conversely, peak voltage is 1.57 the mean or average.
No, the peak-to-peak voltage is 2sqrt(2) times as much as the rms for a pure sine-wave.
Peak voltage will be 1.414 times the RMS. Peak to Peak voltage, assuming no DC offset, will be 2 x 1.414 x the RMS value.
ANSWER: The peak to peak voltage can be found by multiplying 120 v AC x 2.82= 339.41
Its 0.7 times peak-0 voltage, 106 mv RMS.
When you say holdhold supply of 230volts, you are referring to the RMS value, not the peak value.
P-P voltage = RMS voltage * 2 * sqrt (2)Here's an example: house voltage is 120VRMS, which is actually ~169 volts peak - neutral. double this will give peak to peak value.
Conversions of RMS voltage, peak voltage and peak-to-peak voltage. That are the used voltages. The expression "average" voltage is used for RMS voltage.Scroll down to related links and seach for "RMS voltage, peak voltage and peak-to-peak voltage".Answer'Average' is not the same as 'root mean square'. As the average value of a sinusoidal voltage is zero, you cannot convert it to a peak-to-peak value.
It is the highest value of the amplitude, called the peak value. Scroll down to related links and look at "RMS voltage, peak voltage and peak-to-peak voltage". Look at the figure in the middle below the headline "RMS voltage, peak voltage and peak-to-peak voltage".
The average voltage is the rms voltage.Volts peak = volts RMS times 1.414Volts RMS = volts peak times 0.7071Use the link below to an RMS voltage, peak voltage and peak-to-peak voltage calculator.********************************The average voltage is not the r.m.s. voltage.The average voltage of a sine wave is 0.636 x the peak value. Conversely, peak voltage is 1.57 the mean or average.
The same as in single phase with the same RMS voltage.
100v divided by 1.41
Assuming "quoted value" to be RMS value, or average, [what you would see on a meter], the peak would be that value times 1.414. Going backward, peak times .707 is RMS.
It's the RMS value. A 120 volt lamp (light bulb) is rated according to its RMS voltage. Just like appliances in the home are rated at 120 volts (like your fridge, microwave and toaster), or 220 volts (like your clothes dryer). Note that these appliances will have to stand up to the peak voltage on the AC line. Naturally. And the peak voltage on an AC line is 1.414 times the RMS value of voltage. That means in a 120 volt AC line (120 volts RMS), the peak value of the voltage will be 1.414 times the 120 volts, or right at about 170 voltspeak for each cycle.