Serpentine belt and pulley diagrams at www.alldatapro.com
Begin by loosening the tensioner pulley on your 1999 Oldsmobile Cutlass. Put your serpentine belt around the pulleys. Tighten the serpentine belt with the tensioner pulley.
It is the large belt going around all the pulleys on the front of the engine.
At least 3.
I actually have a 1998 Oldsmobile Intrigue with the 3.8 and just recently changed the serpentine belt all u need is a wrench to twist the tensioner pulley to release tension to slide the belt on to the pulleys other than that no equipment is needed if u have following questions send me an email to mr.blique@yahoo.com i hope this is the answer u were looking for
Some where in the radiator shroud or engine compartment there should be a serpentine belt diagram. Follow diagram or picture. Rotate the drive belt tensioner away from the drive belt and install the drive belt on the alternator pulley. also the pulleys the smooth side of the belt goes on the smooth pulleys the belt side with the teeth go on the pulleys with the teeth
turn them
The way it fits around and on top of the pulleys.
Check you serpentine drive belt and pulleys.
Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.
You have a bad bearing in one of the pulleys. Remove belt and spend all the pulleys by hand, they should be smooth and quiet.
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
The serpentine belt is a long belt on the front of the engine. The belt goes over a number of pulleys and powers many things such as the alternator and power steering all at once. The twisting and turning through all of the pulleys like a snake is how it came to be called a serpentine belt.