answersLogoWhite

0

On the gearbox to the right hand side when looking from the front. To the back of the gearbox. Unplug wire and use 10mm spanner to undo. There is an o-ring so you need to pull a bit hard to get it out.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What position does Nick Punto play?

Nick Punto is a second baseman for the Oakland Athletics.


How do you fix the speedometer on a Fiat Punto L Reg that reads 5mph when not moving?

The speedometer on the Fiat punto Mk1 was made with a speedo that reads 5 mph min. There is a needle stopping the speedo from going below this, so you dont need to "fix" anything as this is standard.


How do you fix a speedo sender on a fiat punto speedo reads 0 all times changed the sender on top of the gearbox power is getting to the sender but speedo registers 0 at all times?

The symptoms suggest that the speedo sender drive shaft has sheared. If you have changed just the sender unit on top of the gearbox, it's possible that you have not noticed that the residual piece of the drive shaft remaining in the support tube -on to which the gland nut normally retaining the sensor engages- freely rotates (which it should not do when the engine is not running) or the broken end of the shaft has fallen away unnoticed when you removed the original, apparently defective sender unit -or possibly left attached to the discarded sender and, again, gone unnoticed. A replacement serviceable sender will still install on to the support sleeve but there will be something like a 12 mm gap in the drive shaft where it should engage in the internal sender drive coupling. A new sender will also engage onto the sheared end of the drive shaft but the sender armature will not rotate and your speedo will remain inoperative. (Check the sender itself by turning the sender internal drive with e.g. a screw driver and watch to see if the speedo "kicks" - the ignition has to be on) You will need to remove a small 10 mm a/f hex headed fastener from the engine block immediately below where the sender is located. The sender drive shaft with its integral drive helical gear/sleeve can then be readily extracted together with the support sleeve with its threaded end (onto to which the actual sender is retained by the above mentioned gland nut). It will be obvious if the drive has sheared if the sender has already been seprated from the helical gear drive shaft/sleeve assembly or will immediately become so when the sender and helical gear/sleeve are dismantled....good luck.


What is city mode on a fiat punto?

city drive


What car does Miroslav Klose drive?

Fiat Punto!


Bleed a clutch slave drive mk1 punto?

http://www.fiatforum.com/punto-technical/112771-help-bleeding-clutch-2000-punto.html


How much petrol needed to drive 6.6miles in punto 1.1?

50p


Where is the gearbox oil located on a fiat punto speedgear 2001?

The gearbox oil on a 2001 Fiat Punto Speedgear is located where the car's front drive wheels are. The gearbox isÊpumpkin shaped.Ê


How do you find out what is on your partner's hard drive in their computer if it is password protected?

ASK your partner for the password...... If the don't give it to you then whats on the hard drive is none of your business.... punto!


How do you remove Fiat punto door?

open the door then drive into it with another car and it should remove it safely if not just use a hammer


What does punto mean?

Translation for -Punto , ----- Dot or Point


What is an ideal first car?

A Fieata punto A Fieata punto