To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
The TNS relay on a 1990 Mazda Roadster is located on the drivers side of the car. It will be right beside the brake.
When the brakelite switch fails it fails to on. Replace the brakelite switch. Located under the dash on the brake pedal arm. You will see a push switch that is released when the brake is pressed. Just replace that switch.
The power brake booster is probably at fault.
The flasher on a 1990 Mazda MVP is located under the dash on the driver's side. It is just above and to the left of the brake pedal.
blown wire/fuse
its a ground wire
check fuses, and then check for power to the bulbs check for power in and out of brake switch
you need to take off both caliper bolts and remove the caliper from the carriage... most Mazda calipers will not pivot...
Yes, there is a transmission in a 1990 Mazda RX7 convertible.
Open the trunk.Look up behind the 3rd brake light, you'll see a small bulb harness in the middle.Lightly twist it counter-clockwise, and the harness will come out.Pull out the old bulb.Insert new bulb.These steps are good for all Mazda Miata years 1990-2005.
How can one replace a cornering light on 1990 Mazda dx