Power is VI so 360 watts.
No. Transformers always operate only on alternating current. They will burn up on direct current. That is, if the fuse does not blow first.
The characteristic of the current sources is that it cannot operate in an pen circuit.
That depends if it is an ac or dc motor.
An AC water heater can be converted to operate on DC current but the cost will be large. In the electrical trade anything can be done if enough money is spent to get the results that are requested.
since in an FET the value of the current depends upon the value of the voltage applied at the gate and drain...so it is known as voltage controlled device.. for example..in a mosfet..the current from drain to source depends upon the width of the depletion layer..which in turn depends upon the voltage applied on the gate.. so that is the reason
The television runs on Direct current or DC. Though AC is applied, it is converted to DC and used by the television to operate.
It provides a source of power to the circuit, in the form of direct current electricity, at a potential difference of 9 volts.
No. Transformers always operate only on alternating current. They will burn up on direct current. That is, if the fuse does not blow first.
ac current
Electrical devices use power to operate, but power does not exist without current. Alternately, if current is flowing, power is being stored or used by some electrical device.
The characteristic of the current sources is that it cannot operate in an pen circuit.
alternating current
alternating current
Alternating current is used to operate your electrical appliances.
idmt means inverse definite minimum time. so in this type of relay as the value of operand that is current increase time taken by the relay to operate decrease. higher the current lower is the time taken by the relay to operate. AND dmt definite minimum time (DMT) relay take its minimum time to operate regardless of the value of the current. The definite mean time lag in disc type EM relays is inverse to current as the disc is faster at higher current and hence the less time.Definite mean time lag is possible in static relays by setting the time lag.
An electric stove uses Alternating Current to operate.
altinator