MULTI-REMOTE CONTROL SYSTEM (copied from www.courtesyparts.com) ID Code Entry Procedure 1. Close all doors. 2. Insert key into and remove it from ignition key cylinder more than six times within 10 seconds. (Hazard warning lamps will then flash twice). NOTE - Withdraw key completely from ignition key cylinder each time. - If procedure is performed too fast, system will not enter registration mode.
3. Insert key into ignition key cylinder and turn to ACC position 4. Push any button on remote controller once. (Hazard waning lamps will then flash twice). At this time, the oldest ID code is erased and the new ID code is entered. Do you want to enter any additional remote controller ID codes? (A maximum of four ID codas may be entered, If more than for ID codes are entered, the oldest ID code will be erased.) If No, Go to Step 7. If Yes, Go to next step 5. ADDITIONAL ID CODE ENTRY - Lock doors with lock/unlock switch LH (in main power window and door lock/unlock switch). - Push any button on remote controller once. (Hazard waning lamps will then flash twice). At this time, the oldest ID code is erased and the new ID code is entered. Do you want to enter any additional remote controller ID codes? A maximum of four ID codes may be entered. If more than four ID codes are entered, the oldest code will be erased. If No, Go to Step 7. If Yes, Go to next step. 6. ADDITIONAL ID CODE ENTRY - Unlock doors then lock again with lock/unlock switch UI (in main power window and door lock/unlock switch). 7. Open front door LH. (END) After entering ID codes, check operation of multi-remote control system
The key is inside of the key fob. There is a small switch on the back of fob. Push it towards the outside and hold it. While holding the switch, pull on the key ring and your key will slide out.
trying to set up and program 2003 Nissan altima key fob
How do you program the remote key fob on a 2005 Chevy Malibu maxx
Take it to your Buick dealer is how.
I went to a lock shop that specialized in keyless entry. They sold me a Fob for $70.00 because i didn't have one & they programmed it.
How do you program a key fob to a 2003 Chevy Malibu
I've got a better question, why is this question in the Chevy venture forum ?
To program any kind of key fob you have to take it to a dealership.
How do I re program my key fob for renault laguna estate 1997?
you need a scanner to program your new key to ur NATS IMMU. call me, i can help +639176222223 -Jerry
You don't. Take the car and the new fob to a caddy dealer or a locksmith who has the equipment to program it.
You will get a Keyless Entry Remote Fob Clicker for your 2000 Nissan Maxima SE.