Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
yes
i do not know go to a car stereo install ... store
Insert the key into the ignition. Push the release/switch button at the bottom of the cylinder, and pull the cylinder out.?æ
If you are talking about the ignition cylinder lock, the part where the key goes: Turn the switch to "ON". There is a square pin on the front of the switch (side closest to dash). Push the pin in and pull the cylinder out. Mine was locked so I had to drill it out.
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
Remove the retaining nut from the ignition switch. Pull the switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.
Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
uh you pull it out :)
pull the cover off the steering column and there should be a wire connected to the ignition switch. pull it off and put the key in the switch.
The 1991 Mercury Sable ignition switch is held in place with a retaining ring. Loosen the retaining ring. Pull the ignition switch out. Remove the wiring harness from the rear of the ignition switch. Reverse the process to install the new ignition switch.
You can remove the 1999 Cadillac Deville ignition switch by removing the retaining ring. The retaining ring will be at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the back of the switch. Reverse the process to install the new switch.