there should be an idle adjustment on the right side of it
To change the choke cable on an Arctic Cat 400 ATV, first, ensure the ATV is turned off and secure it. Remove the handlebar cover and locate the choke cable connection, then unscrew and detach the old cable from the choke lever. Install the new choke cable by threading it through the handlebar and securing it to the choke lever, ensuring it operates smoothly. Finally, reassemble any removed parts and test the choke function before use.
Their should be a red swith on one of the handles.
how do you replace a choke cable on a 2001 Honda 450 foreman
on the carburetor
Just to the right of the LH grip you have rotating choke lever. All the way up is no choke, Rotated all the way down is fully choked.
It should be on the carb!
on the hand grip were ur brake is on right side!!
Carburetor not adjusted correctly
try cleaning your carburetor thoroughly
I would start by looking at the fuel filter,a clogged filter wil allow enough gas to idle ,but when you punch it ,the increased air with a small flow of fuel will stall it,you may also want to check the choke is not stuck closed.
The increase/decrease screw on the Timberwolf ATV engine is used to adjust the idle speed of the engine. Turning the screw clockwise will increase the idle speed, while turning it counterclockwise will decrease the idle speed. It is important to adjust this screw carefully to ensure the engine runs smoothly.
Keihin pvk 36mm with electric choke