Carburetor not adjusted correctly
Have you changed the main jet? Sounds like needle not seating fully or correctly.
take off the carbs and clean them out with come carb cleaner. Might be the choke cable sticking, or float bowls level is too high
Does it idle high all the time or just for a bit after you start it? There are a couple things you could check such as: 1- Defective throttle cable 2- Idle srew on you carburator is set too high 3- Choke is on Good Luck!
the choke is on
The function of a choke in a lamp circuit is to produce high voltage. In tubelights, the high voltage is essential for ionisation of the gas which is present in tubelights.
I am not 100% sure but i think the stall speed of the F-15 eagle is around 500km\h I also saw a documentary that says the stall speed is 530km\h
Yamaha YAS -26 is a very good type of sax it makes a high sound
It's OK for your bike to idle high, briefly, as it warms up. Just move the choke to the half-way point or so before taking it off completely. A gradual reduction in the choke will make shut-offs less likely.
A choke is an inductor. An inductor resists a change in current, by presenting a higher impedance to high frequency parts of the spectrum. A choke, then, passes DC, but does not pass high frequency AC, such as noise.
An engine usually has a higher idle speed when the ac is running. If the high speed idle does not operate then the ac will cause the engine to stall.
10 feet is the minimum for any structure that a horse will enter.
put a bigger carb on it.