Miata wheel bearings are replaced as an integral hub / bearing assembly. Do a search on www.Miata.net for more detailed information. This is true of the FRONT hub assembly, but the rear assembly in the 1990-2005 cars have a replaceable bearing that is the same for all years. Removing the bearing requires removing the entire assembly from the car so the bearing may be pressed out, or gently hammered out with correct drift sizes. The bearings are USUALLY NOT the cause of rear suspension noises. The CV joints are much more likely to fail than the bearings.
Front or rear?
How do you replace a rear wheel assembly?
Remove the tire and wheel from your 1982 Chevy Corvette. Remove the brake assembly. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
I am getting quoted 300-400
Begin by removing the rear tire and wheel. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
The 2001 Mazda Tribute came equipped in a 2.0L L4 and 3.0L V6. The rear wheel bearing are sealed assemblies. These can be pressed in to complete the install. The OE replacement rear wheel bearings for this application are SKF #GRW266. It is recommended to replace the wheel bearings in pairs.
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
How do you change rear wheel bearing on 1999 alero?
The wheel bearing
The rear wheel bearing, on a Nissan Maxima, can be removed by first removing the rear wheel. Next, remove the axle cover. Slide the wheel bearing off of the axle. Reverse the process to install the new wheel bearing.
Remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.