0
What else can I help you with?
How do you remove the stock radio in a 1988 Delta Eighty-Eight?
You have to remove the whole lower panel of the dash with either Alan or torch wrench.
1988 Oldsmobile delta fuel display reset button?
Check
Where is fuel pump locatede on 1988 Delta 88 Oldsmobile?
Fuel injected? In the fuel tank.
Where can you download schematics for a 1988 Oldsmobile Delta 88 online?
http://www.alldata.com/products/diy/index.html
Can you fit 24 inch rims on a 1988 Oldsmobile 98 regency?
How can I put 24s on 1981 delta 98
What if the fuse for the radio keep going out on your 1988 Oldsmobile 98?
wire crossed or bare wire
Do you have a vacuum diagram 1985 delta 1988 olds?
Read your questions before posting them. What you just asked makes no sense. Do you mean an Oldsmobile Delta 88 from the year 1985?
How do you change a cam shaft positioning sensor on a 1988 Oldsmobile Delta 88 3.8L?
See the Related Links for "Here" to the bottom for the answer.
How do you locate a crankshaft sensor on a 1988 Oldsmobile Delta 88?
To locate the crankshaft sensor on a 1988 Oldsmobile Delta 88, first, ensure the vehicle is safely elevated and the battery is disconnected. The crankshaft position sensor is typically found near the engine's crankshaft, often at the front or rear of the engine block or near the timing cover. You may need to remove some components, like the air intake or accessories, for better access. Consult a repair manual for specific diagrams and detailed steps for your model.
How do you remove the radio from a 1988 Plymouth reliant?
remove all of the screws holding on the wood grain pane wrapped around the steering wheel and radio then remove two bolts holding the radio in an there ya go
How do you replace ecm 1988 Oldsmobile delta 88?
To replace the ECM (Engine Control Module) in a 1988 Oldsmobile Delta 88, first disconnect the negative battery terminal to prevent electrical shorts. Locate the ECM, typically found under the dashboard or in the engine compartment, and unbolt it from its mounting bracket. Carefully unplug the wiring harness and remove the old ECM, then install the new one by reversing the process: plug in the wiring harness, secure the ECM, and reconnect the battery. Finally, start the engine to ensure the new ECM is functioning correctly.
1988 delta Oldsmobile 3800 motor can you bypass the ac unit with the belt?
yes just buy the belt for it and tell them it has no air and use the routing diagram under the hood for the one without air
