disconnect the battery, and remove the starter. remove the front wheels and drive axles. disconnect any trans. cooler lines, sensor wires, shift linkage, trans. dip stick, or anything bolted to the transmission. find support for the motor, and for the transmission. disconnect any transmission mounts. remove bellhousing bolts, and drop transmission out of car, be careful of any wires lines or brackets you may have forgotten or over looked.
Correction: It is a 1995 Chevy Corsica. Not a 1996.
Remove the wiring harness from the back of your 1996 Chevy Corsica blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
remove the two nuts holding the master cylinder on the power brake booster
Ask the same question at batauto.com in the forum for transmissions. Koug
E
in the front of the motot
under washer reservior.
on automatic transmission
To change a velocity joint in a 1996 Chevy Corsica, you will need to first lift the vehicle and remove the wheel. Then, disconnect the drive shaft from the transmission and remove the old velocity joint. Install the new velocity joint, reconnect the drive shaft, and put the wheel back on before lowering the vehicle.
10w30 premium oil.
WHAT DOES THE DIAGRAM SHOW?
Dot 2