Yes but you would need to do a lot of work like removeing intake manifolds,heads,exoust,ext...
Not for the inpatient
on top of the starter of front of your engine block
Open the hood.The resevoir is located on the left top side of the engine.
follow the top radiator hose to the engine. its under the cover.
the 1999 Chevy venture does not have distributor cap, he has a electronic module assembly, assembly is module and three coils, they are located on the top of the engine, back in the medium near of the firewall.
On top of the engine, passenger side under the windshield.
Just did my daughters 98. I removed the coil pack on the back top of the engine. The rest was done in the braille method. Feel, but no see. bob
on my 2000 Chevy Venture, it's the one that sits pretty much on the top of the belt drive.
The map sensor on a Chevy venture is located under the ignition module on top of the rear cilinder bank. To access it you have to remove the ignition module. It helps a bit if you rotate the engine forward and you can lower the engine for about 4 inch. you will have to unbold the subframe on the frontside, use a hydraulic jack to take the weight and lower it carefully. this gives you the extra space needed to work on it.
remove the intake on the top of the engine. they are under it. There will be 6. for a L6 engine and 8 for V8
can i pull a chevy caviler motor 1998 2.2 4cylinder from the top or do i have to drop it from below
Trace the top rad. hose back to the block. It is right inside there. You will have to remove the throttle body to gain access to the space there.
When the engine is cold, remove the radiator cap, top off with a 50/50 mix, and start the engine. This will allow air to escape from the radiator. It may also have bleeder valves located high on the cooling system. The location will be listed in your owner's manual.