The belt is quite easy to change on the master van, mine is the 2.2 diesel. you are supposed to have a special tool to raise the tensioner.
I don't have one so what I do is to slide my trolly jack under the tentioner, take a long flat blade screw driver (an old one)place the handle into the jack's cup. the slot end of the screw driver goes into a slot located on the tensioner wheel, this is a little fiddly and may take a few attempts.
Once the wheel has been suitably raised the old belt can be pulled free, place the new belt onto the pullies, taking care that it runs in the same order as the old belt, the belt will be tricky to get over the final, lower pulley, take care here as this pulley is plastic, insert an Allen key into the center of the lower pulley and turn to wind the belt on, do not attempt to leaver the belt into place!
Hope this helps, I spotted this questopn while looking for information on a Kangoo steering rack! don't you love French cars
fanbelt on a 306 hdi how do fit it
i want to change the fanbelt on my vectra 2001
Will a Renault Megane V Plate ignition barrel fit a Renault Megane Cabriolet R PLate?
i paid £15.00 to replace my water pump how long does it take to fit
Yes they would fit with the right seat rails attached
Just been quoted £140 for a pair of rear bearings atKwik-fit
To fit a thermostat on a Renault Laguna, check both upper and lower hose of the car. Check the hose that is cool and fit the thermostat on the engine side of that hose.
yes you terd
no
To fit a washer pump in a Renault Clio, remove the wipers and scuttle panels. Then undo the 3 nuts. Fit the washer pump and put back the 3 nuts.
no
Yes they will but rear will reequire a smaller spacer to clear the rear damper.