Normally on most vehicles in need of lower "A-Arm" bushings the lower arm must be completely removed as the bushings are pressed on. Once the arm is removed you can easily press out the old and the new in. If you don't have a press most machine shops will usually do it for $10.00-$20.00. By the most part they are not that difficult. Use a manual and adequate jack stands. Good luck!
you have to hammer out the three rivets that hold it to the control arm. but do yorself a favor and replace th whole control arm because the bushings on the arm are well known for falling out.
when should the vapor canister be replace on a 1996 pontiac sunfire
Where is the fuel idle control valve for a 2002 Pontiac Sunfire
There is no speedo cable on a Sunfire.
Pay a mechanic to replace it
how do you repair an inner tie rod for a 96 Pontiac sunfire no repair,replace with new.
You can replace a timing chain on a 2002 Pontiac Sunfire by visiting a local mechanic and having him take care of it for you. This is a tricky part to change yourself.
The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.
Most problems with an automobile door hinge is worn out bushings. There is a small rubber bushing behind the adjustment bolts. Replace the bushings.
OK ... Here's the REAL answer: You cannot change the bearings on a Pontiac Sunfire. You must replace the "Hub-Assembly" they will be the same on both sides .
How is the ignition key switch replaced on the 2000 Pontiac Sunfire? And after replacing the switch would I have to have it Towed to the Pontiac Dealer in order to have the car key programed to the Computer?
yes