how to change a brake light on 2002 Nissan altima
http://www.paulstravelpictures.com/Nissan-Altima-Rear-Brake-Light-Bulb-Replacement-Guide/Nissan-Altima-Tail-Light-Bulb-Replacement-Guide-011.html here you can see every step to that question.. I just did it.. and works :) by Paulo Fernando!!
Bulb burnd out replace
To replace the brake light switch on a 2000 Nissan Altima, first disconnect the negative battery terminal to ensure safety. Then, locate the brake light switch, which is typically found above the brake pedal. Remove the electrical connector from the switch and unscrew it from its mounting bracket. Finally, install the new switch by reversing the removal steps and reconnect the battery.
low brake fluid
brake light and battery light is on
To replace the brake light switch on a 2010 Nissan Altima, first disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is usually mounted above the brake pedal. Remove the electrical connector and the mounting bolt or clip holding the switch in place, then install the new switch by reversing the removal process. Finally, reconnect the battery and test the brake lights to ensure they function correctly.
how do you replace shift gear light on a 1998 le altima car?
To replace the center brake light in a 2002 Ford Thunderbird, first, open the trunk and locate the plastic cover over the brake light assembly. Remove the cover by unscrewing any screws or unclipping it. Next, twist the bulb socket counterclockwise to release it, then pull out the old bulb and replace it with a new one. Reassemble the socket, replace the cover, and test the brake light to ensure it works properly.
I think you are talking about the center high mount stop light when you say "rear interior brake light". The 2005 Nissan Altima center high mount stop (third 3rd brake light) bulb replacement: Purchase the correct replacement center high mount stop (third 3rd brake light) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the center high mount stop (third 3rd brake light) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. If there are multiple bulbs, you may want to consider replacing all at the same time in order to keep brightness and color equal (optional).
Look inside the trunk under the light for bolts to remove the light.
I found under the drivers dash on the brake pedal the brake light switch to be faulty. It can operate the tail lights but not the center brake light replace it. This was the case on my 90 vette.