i need x parts and need leg ends with locks show me parts only so i may pick. x patrs
There is an adjuster at the handbrake lever you have to remove the plastic surround to access this adjuster. However there is an aduster on each rear wheel as well. If you remove the wheel you will see a small round rubber plug you will need to remove this plug and rotate the disk whilst looking into the hole and near the bottom of the rotation you should be able to see an adjuster mounted between the brake shoes. You should be able to turn the adjuster with a flat screwdriver.
Under the hood below the headlight is a black plastic assembly. There is one plastic wing nut. This is the adjuster for the headlight.
It is on the drivers side of the firewall. It is a strange looking almost cylinder looking plastic contraption . Has one long bolt in the center, to remove and two side nuts. This rarely requires replacement.
My mother is 80, has COPD and is considering a total knee replacement
Very very carefully the screws like to get rusted in there and when you go to loosen them the plastic housing that holds the bulb will break trust me lol i have been looking for a few months now for a replacement plastic lol.
One can purchase a replacement for plastic vents from hardware and building supply stores. Alternatively, one can also find these online at sites such as eBay and Amazon.
walmart and lowes
I have an 08 Burgman 400.For mine it is located underneath the bike in front of the rear tire. You'll find it behind a plastic hinged cover. The tool for the adjuster is located with the tool pouch in the compartment under the seat.
where can you buy plastic swing seat feet grips or caps that go on the bottom
No polycarbonate plastic and acrylic plastic make a better replacement for glass than vinyl. There are also some applications for which nothing replaces real glass.
Salvage yard or dealer.
No, not a good idea. Best to get a replacement.