My security light was on for approximately 2 months before one day she just didn't crank. I tried the reset stuff and ended up having her towed to the dealership where they installed a new ignition cylinder which also required a new set of keys. The total cost was roughly $450 and I feel well worth it. I wouldn't want to by-pass the system or even have my husband attempt to fix this sort of malfunction. I had read that someone said the cost would be $1,000 which is totally way off. When I get ready to sell my 2002 TransAM w/RAM Air I want it to be in top condition. My black beauty only has 81,000 miles and I'm still lovin' it!
if the light goes off it's probably the starter...
To reset the fashing dash blue security light............disconnect the hot lead on the battery and after about 3 minutes, reconnect it. Light should be off now.
You can reset the 2002 Chevrolet blazer security system by removing the security system fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.
vice & oil reset 2002 sl500
how do i reset timing belt light on 1hz
Howdo i reset my radio security code ml 500 2002
Once you have repaired the cause of the light, it will reset itself.Once you have repaired the cause of the light, it will reset itself.
You can't reset that light...there is no such thing as a 2002 Honda Element...they didn't come out until 2003.
It is very easy to reset the check engine light on a 2002 Volkswagen Cabrio. The negative battery cable can be taken off for one minute and replaced to reset the light.
To reset the security light on an Oldsmobile vehicle, first the driver must turn the key to the "on" position, without starting the engine. Next, he or she should turn the key to attempt to start the engine, but not completely, so that it doesn't start before moving the key back to the "on" position. After about 12 minutes, the light will?æbe reset, and the key should be removed.?æ
A 2002 Jeep Wrangler does not have a reset switch.