right
it's located right under the back seat. There should be two clips on the left and right of the seat right where the floor board and seat meet. Unclip the seat remove the black guard and the top of the fuel sending unit should be visible.
The back seat removes. Under the right and left seat there are buttons you push and the seat should remove.
from the perspective of the drivers seat
First disconnect the connectors under the seat. Remove the 3 bolts (Front Left, Front Right, Rear Right). Remove the nut from the Left Rear. Lift seat up and out.
Not exactly sure but on a B (it should be the same) it is on the right side of the left-hand seat mount.
You determine left and right by sitting in the driver's seat. Driver's side is LEFT, Passenger side is right.
From the back of the seat, at the lower right corner, there is a lever that should be pressed to the left to release the seat and allow it to fold down. The same lever is used, in the same manner, to open the seat.
From the drivers seat out
with right hand place key in lock ,turn key to unlock seat and lift with left hand . with your right hand strike the seat in the middle with your fist in the direction of the fuel tank seat should be free to lift off . if not repeat . to fit seat place the seat on top of the bike locate and strike the seat in the middle to locate . easy as abc.
By sitting in it.
* Unlatch the rear seat back and tilt forward * Unhook the outer side belt retractor from the rear seat back * Remove the spacer from the right key pin * Slide the seat back to the right and disengage the left key pin from the left key slot * Slide the seat back to the left and disengage the right key slot from the right key slot * Remove the seat back * Press the seat cushion retainer to the rear with a screwdriver * Lift the seat cushion up and remove it
look just under the edge of the seat where it meets the carpet. you will see two bolts. one on the left, one on the right. they should be half inch bolts, or thirteen mm.remove them, and the seat will lift out.