Not unless you really want to; some will run out when you remove the hose but just catch it in a pan and put it back when finished. Since the long life coolant is very expensive, drain the radiator halfway (or at least below the thermostat level) with a small pump into a clean bucket. It is important that the fluid remains clean, contaminants will ruin the internals of the coolant system over time. When completed put the coolant back in and bleed the system. Hope this helps. "G"
The first step in how one can replace a thermostat in a 2001 Cadillac DeVille is to remove the housing which surrounds the old thermostat. The radiator hose will need to be removed and drained and then the thermostat can be removed. Remove the old thermostat gasket and then insert the new thermostat as well as the new gasket. Attach the radiator hose and place the drained fluid back into the radiator filler cap.
Follow the upper radiator hose from the radiator to the top of the engine. There will be 2 bolts once you have drained the radiator you can remove these bolts that hold the waterneck housing down lift it up, and there will be the thermostat. Follow the upper radiator hose from the radiator to the top of the engine. There will be 2 bolts once you have drained the radiator you can remove these bolts that hold the waterneck housing down lift it up, and there will be the thermostat.
Unless I have drained the block and radiator, I have filled the radiator from my expansion tank in every vehicle I ever had. If you have drained your radiator and it is cold, take off the cap and fill it that way. If you have drained the engine block and have not change your thermostat, you will need to keep filling your expansion tank until everything is filled back up. I recommend changing your thermostat.
16 qts when completely flushed and drained
The thermostat is in the bottom radiator hose housing where it connects to the motor. The radiator needs to be drained, the bottom hose removed, and the housing removed to get to the thermostat. Make sure to clean all old gasket material from the housing, and fit the new thermostat in the proper direction.
A radiator is held on the mounting brackets. Before removing the radiator on a Toyota Starlet it will need its coolant drained. Remove all the mounting bolts and disconnect the hoses to pull the radiator off.
Changing the thermostat on a 2002 Chevrolet 4.8 liter engine is simple to do. First, follow the upper radiator hose to the thermostat. Then drain the radiator hose. After the hose is drained, remove the clamps and bolts holding the thermostat housing in place. Then remove the old thermostat and replace with a new one.
Look closely at the radiator. Check the bottom corner of the radiator that is opposite of the lower radiator hose. If there is no drain plug or petcock, then the coolant will need to be drained by removing the lower radiator hose.
To change the thermostat on a 1999 Honda Cr-V the radiator first has to be drained of its coolant. Locate the thermostat and proceed to remove the housing, which will reveal the thermostat inside. Simply remove the old thermostat and insert the new part. Installation is the reverse of the removal.
Replacing the thermostat in a 2000 Ford Focus SE wagon is very easy to do. First the radiator hose will need to be disconnected from the thermostat. After the hose is drained and disconnected, the thermostat can be removed by taking the two bolts off.
This question is not complete. . Need to know if you've replaced radiator, thermostat, hoses etc. Are you asking this question *after* yo checked the thermostat, changed, added or drained the system?
Remove the drain plug from the bottom of the radiator. Allow the coolant to completely drained out. Replace the drain plug to its original position. Fill the radiator with new coolant.