Want this question answered?
What kind of bearings??Engine, wheel, trans,diff.?????
Should be 12 degrees before top dead center
Should be 12 degrees before top dead center
Yes..you should be able to. You'll have to take off the starter, remove the front engine mount to be able to lift the engine slightly then remove the oil pan.
In the center rear of engine.
Pontiac V8's from 1955-1978 (except 265,301, and 303 race engine) all used connecting rods with the same dimensions. Center to center Legnth=6.625 Big end bore= 2.375 (2.250 with bearings installed) Small end bore= .980 Big end width= .995-.996
It all depends on the bearings that you need to replace! Get some quotes! If it is bearings inside the engine, then the mechanic you go to is going to have pull the engine anyways, so if there are no other problem with your engine but some bearings then i would just have the bearing replaced, but if you have other problems due to the bearings going out, then i would replace the engine. Hope i helped
Wheel bearings? Axle bearings? Differential carrier bearings? Engine main bearings? Engine rod bearings? Engine cam bearings? Need more info to help you.
roller bearings are only needed if engine has roller bearings, u would replace bearings with same bearings that are in engine and cam specs
On relay bracket on center of firewall in engine compartment. It is on the left side (drivers side), center
probably it can be changed but if you change the whole alternator you will gain a new alternator for your engine in opposite of changing only the bearing which is not guaranteed.
Dead Center at about 190 Degrees