0
Should you use a 13amp in your plug or a 3amp for a side light?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What difference between 13A and 5A plugs?
13amp have a high breaking capacity than 5amp plug
Trailer light hookup for a 98 ford explorer?
On the drivers side of the tail light there is a plug. Get up under the bumper and you will see a round plug and you have to do is unplug the plug from the light and plug in the wiring harness. The wiring harness will act like a patch and connects in about 15 seconds. Just make sure you have the right harness. The plug should be round.
Where is the plug to get the codes for a check engine light for 2000 acura integra?
The plug is under the dash on the passenger side. It should be a green plug just under the carpet..
When you plug your xbox power supply into the wall the orange light comes on as usual but as soon as you plug the power supply into your Xbox the light turns red and the Xbox wont turn on?
While the Xbox is turned off, plug the power supply into the xbox first. Then plug it into the wall and it should be orange. Turn on the xbox and then the light will change to green.
How do you you replace the headlights on a 2000 Hyundai accent?
It depends on the headlight. If it's a solid light then there should be screws in front of the headlight that hold it in. If it's a holigen bulb then you have to open the hood and go behind the headlight, find the wires to the light which are attached to a plug, turn the plug to the left slightly and pull. the light should just pull out and push the new one in it place.
How do you get to bulb in tail light of a 2005 expedition?
Lift the rear tailgate and look at the light. There should be one or two bolt heads visible. Take these out and the whole lens assembly should come out and the plug for the light exposed. This plug is a 1/4 turn and will come out allowing you to change the bulb. Just reverse the above directions to reinstall. Hope this helps.
Can you convert a garage light socket to accept a three prong shop light plug in?
If you want to you could remove the light socket and put in an outlet then plug your light into the outlet.
How do you convert a wall light to a plug-in?
Simply replace the light fixture with a plugin. There is most likely a box behind the light that will either accept a plug as is or a cover place can be used to allow the use of a plug in that box.
How do you reset the service engine light on a 2001 Chevy Venture van?
Disconnect the battery for about 10 minutes to a half an hour that should clear it if not get a obd 2 and plug it in there should be a connector under the drivers side dash plug it in it will tell ya what to do
How do you plug in the led light on a mist maker machine?
You can plug in the LED light on a mist maker machine using a fog machine.
Your Chev 6.2 will not start when warmed up. No glow plug light. When eng cools and glow plug light comes on it will start?
you need to check your glow plug relay it is most likely going out you can jumper it to see if the glow plug light will come back on to start engine
How do you light a light build?
you put it in where ever it needs to be plug-ed in.
