0.30
To Determine what spark plug is in your 16hp enging you would need to be more specific. It could have a Briggs and Stratton engine or it could have a Kohler engine. Both engines use different spark plugs. The spark plug for the Kohler engine is part number 32295-1. The part number for the B&S engine is 43591-7
champion rc12yc
Sounds like a ignion coil.
On the inline six cylinder engine , spark plug # 6 is the rear spark plug On the V6 engine , spark plug # 6 is the rear plug on the drivers side of the engine On the V8 engines , spark plug # 6 is the 2nd plug from the front on the drivers side of the engine
Hi, it depends on the serial number of you engine. the only information i have is for serial numbers above EUROPE:9157229 USA:4709592 spark plug: AC-V40FFK OR CHAMPION L78V Regards john
If it is a Kohler motor it is a Champion H10 ,
Champion RA8HC has the same thread, seat, reach, hex size, and terminal type. I ordered a Kohler plug from Amazon and they actually shipped me this Champion Plug.
It is important to gap the spark plugs of an engine. The spark plug gap measurement for this engine is 0.044 inches.
the spark plug provides the spark necessary to ignite the fuel and air in the engine, which allows your engine to run. without spark plugs, your engine wouldn't start.
Remove the spark plug wire from the spark plug. Use some heavy gloves or a set of insulated pliers to hold the spark plug wire about 1/4-inch from the engine block (ground) and crank the engine - you should see a spark jump from the wire to the engine ground. For a better check, use another spark plug and put it on the spark plug wire and use it as a "jumper" from the wire to the engine ground.
bad spark plug wire.
what is the right spark plug gap for a 4.7 4 wheeler engine