0
the sensor is located in the differential housing on the back of the transmission. (this is the speedomoter sensor, it is in the housing that the pass axle shaft slides into) For the 3.3/3.8L, it is near the bell-housing facing the firewall, as it senses the magnets that are on the torque converter when it spins. (that is the engine speed crank position sensor)
Wiki User
∙ 15y ago
Wiki User
∙ 11y agoAbs sensors are at the wheel bearings.
Vehicle speed sensor is on the pass side axle output housing on the 3 speed trans.
The input and output speed sensors are on the front of the transmission case on the 4 speed trans.
Add your answer:
Earn +20 pts
How long does it take a radio signal from the Voyager spacecraft to reach Earth if the distance between Voyager and Earth is 4.16 109 km?
The speed of light is about 300,000 km/sec. Just divide the distance by the speed of light. The answer will be in seconds; divide by 60 to get minutes, by 3600 to get hours, or by 86400 to get days.
What is oss on fuse panel on jeep?
output speed sensor
Where is the output speed sensor in a 1995 Jeep Grand Cherokee?
standing at the radiator it is the 2 wire sensor all the way to the right of the transmission case. standing at the radiator it is the 2 wire sensor all the way to the right of the front of the transmission case
How much are transmission sensors for 1998 Jeep Grand Cherokee?
You're probably talking about the input speed sensor and/or the output speed sensor (if your model has one). They are about $20-$30 a piece, it's a cheap fix.
What is error code PO725 on 2000 jeep grand Cherokee?
Engine speed sensor circuit malfuntion
Where is speed control sensor on a 1995 Plymouth Voyager?
If you are refering to the vehicle speed sensor (VSS) it is on tranny by where the axles are
What does a speed sensor do in a 95 Plymouth Voyager?
the speed sensor senses the speed and tells your transmission when to shift , it also controls your speedometer.
Location of speed sensor on 1997 Plymouth voyager?
It is located in the passenger side axel housing for the CV joint, on the rear side of the engine compartment.
Where is the input speed sensor on a 1990 Plymouth Grand Voyager?
The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.
Where is the trans sensor located on a 96 Plymouth voyager 3.0?
right on the trans they are plug ins one is a speed sensor
What does an output speed sensor do on a 1996 Plymouth Voyager?
It measures the speed of the output gear of the transmission. It is used for shift timing.
How do you repair a code P0500 on a Plymouth Voyager?
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
How do you adjust idle on 98 3.0 Plymouth Voyager?
It is not adjustable. If the idle speed is not correct, then you have a sensor/actuator/computer issue.
What does a input turbine sensor do on a 1996 Plymouth Voyager?
It measures the speed of the transmission input shaft. The transmission computer uses this info for shift timing.
How do you install a speed sensor on a 1996 Plymouth Grand Voyager SE?
You need to look on your transmission there should be 2 of them I have A 96 PLYMOUTH VOYAGER 3.0 liter and it has 2 on the transmission on it just match up ur sensors not very hard. sorry best i can do.
Where is the neutral safety switch location on a 1998 Plymouth Grand Voyager?
On the four speed automatic, it is inside the transmission on the valve body. On the three speed, it is on the front of the transmission case.
Does a 1994 Plymouth Voyager have a governor in the transmission?
The three speed does have a hydraulic governor in the transmission. The four speed does not.
